GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2009 🢒 G8 🢒 Seats 🢒 Seat Hardware, Trim, and Upholstery 🢒 Child Restraint Tether Anchor Replacement

Removal Procedure

    Note: DO NOT attempt to repair or alter the child seat anchor assembly. If the child seat anchor assembly is damaged, replace the entire assembly. Altering the child seat anchor assembly could result in personal injury.


    Object Number: 2043542 Size: SH
  1. Using a suitable tool open the child seat anchor assembly cap (1). Remove the child seat anchor assembly to body retaining bolt (2) from the child seat anchor assembly that is being serviced.

    2. Object Number: 2043543 Size: SH
  2. Remove the child seat anchor assembly (1) that is being serviced from the rear window shelf.

Installation Procedure

    Object Number: 2043543 Size: SH
  1. Install the child seat anchor assembly to the rear window shelf.

    2. Caution: Refer to Component Fastener Tightening Caution in the Preface section.


    Object Number: 2043542 Size: SH

    Note: Ensure child restraint assembly is installed as per illustration, failure to adhere to this installation will result in incorrect operation of the child restraint assembly.

    Note: Ensure that the anchor fitting is parallel to the vehicle centerline.

  2. Install the child seat anchor assembly to body retaining bolt (2) and tighten to 20 N·m (22 lb ft).
  3. Close the child seat anchor assembly cap (1).