For 1990-2009 cars only
Removal Procedure
- Disconnect the wiring harness connectors to the intake air temperature (IAT) sensor (3) and the mass air flow (MAF) sensor (2).
- Loosen the clamp securing the air intake duct to the throttle body, then loosen the clamp securing the MAF sensor to the air cleaner upper body.
- Remove the duct together with the IAT sensor and the MAF sensor still installed.
- Remove 3 retainer screws securing the air cleaner upper body .
- Remove air cleaner upper body and air cleaner filter assembly.
- Remove the 3 retainer screws securing the air cleaner lower body to the fender inner panel insulators.
- Remove the air cleaner air inlet duct (1) from lower body, then remove air cleaner lower body.
Installation Procedure
- Install the air cleaner lower body onto the mounting insulators.
- Install the air cleaner inlet duct to the lower air cleaner lower body (1).
- Install the retaining screws and tighten to the correct torque specification.
- Assemble the air cleaner element into the air cleaner upper body and place the upper body onto the lower air cleaner body.
- Install the 3 retaining screws securing the upper air cleaner body to the lower and tighten to the correct torque specification.
- Reinstall the intake air duct and MAF sensor to the throttle body and upper air cleaner body. Reinstall and tighten both duct clamps to the specified torque.
- Reconnect wiring harness connectors to the IAT (3) and MAF sensors (2).
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the air cleaner lower housing to 10 N·m
(89 lb in).
Tighten
Tighten the air cleaner upper housing to 5 N·m
(44 lb in).
Tighten
Tighten the intake air duct clamp to 2 N·m
(18 lb in).
