Notice: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:

1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
2. Loosen the fuel filler cap to relieve any vapor pressure.
3. Disconnect the negative battery cable.
4. Remove both fuel rail covers.



5. Disconnect the engine compartment fuel feed pipe (4) at the fuel rail.
6. Disconnect the engine compartment EVAP pipe (1) at the EVAP canister purge solenoid.
7. Disconnect the engine compartment fuel feed pipe at the chassis fuel feed pipe (3).
8. Disconnect the engine compartment EVAP pipe at the chassis EVAP pipe (2).
9. Cap the fuel pipes to prevent possible fuel system contamination.

1. Install the engine compartment EVAP pipe at the chassis EVAP pipe (2).
2. Install the engine compartment fuel feed pipe at the chassis fuel feed pipe (3).
3. Install the engine compartment EVAP pipe (1) at the EVAP canister purge solenoid.
4. Install the engine compartment fuel feed pipe (4) at the fuel rail.
5. Install the fuel filler cap.
6. Inspect for leaks.
7. Connect the negative battery cable.

7.1.	Turn ON the ignition for 2 seconds.

7.2.	Turn OFF the ignition for 2 seconds.

7.3.	Turn ON the ignition.

7.4.	Inspect for fuel leaks.

8. Install both fuel rail covers.