For 1990-2009 cars only
Removal Procedure
- Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
- Using a small screwdriver, push in on the center of the front seat track outer covers (1).
- Unclip the covers (1) from the seat track and disengage from the side sill trim.
- Pull the covers (1) apart and remove.
- Remove the seat belt bolt access cover (1) then remove the seat belt bolt (2), seat belt anchor (3), washer (4) and spacer (5).
- Carefully lift the door sill plate trim plate (6) from the door sill plate (7) starting at the front and moving rearwards.
- Remove the door sill plate-to-rear quarter panel retainer (8).
- Remove 4 door sill plate retaining screws (9).
- Pull upward on the rear edge of the door sill plate (7) towards the center of the vehicle to release 2 sill plate-to-rear quarter panel retaining clips (10).
- Remove the door sill plate (7) from the vehicle.
Installation Procedure
- Position the door sill plate (7) to the vehicle.
- Push downward on the rear edge of the door sill plate (7) towards the center of the vehicle to install 2 sill plate-to-rear quarter panel retaining clips (10).
- Install 4 door sill plate retaining screws (9).
- Install the door sill plate-to-rear quarter panel retainer (8).
- Install the door sill plate trim plate (6) to the door sill plate (7) starting at the rear and moving forward.
- Install the seat belt spacer (5), washer (4), seat belt anchor (3), bolt (2), and seat belt bolt access cover (1).
- Push the covers (1) together and position in the vehicle.
- Clip the covers (1) to the seat track and lock in place to the side sill trim.
- Install the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the 4 door sill plate retaining screws to 2 N·m
(18 lb in).
Tighten
Tighten the seat belt bolt to 42.5 N·m (31 lb ft).
