The following service procedures require either a programming or a setup event performed for a complete repair.
ECM Replacement
If the engine control module (ECM) is replaced, the following procedures must be performed:
- Program the ECM --Refer to
Service Programming System (SPS)
.
- Link the ECM to the Powertrain Interface Module (PIM). The ECM must be linked to the PIM using the Techline Information System (TIS).
- The CKP Variation Learn--Refer to
Crankshaft Position System Variation Learn
.
ECM Reprogramming
| • | Engine Oil Life Remaining--When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed. |
| • | Transmission Fluid Life Remaining--When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was reprogrammed. |
Setup for Component Replacement
The replacement of some components will require a setup procedure for complete repair.
If any of the following components are replaced, a CKP Variation Learn Procedure must be performed. Refer to
Crankshaft Position System Variation Learn
.
| • | Any engine repair that disturbs the crankshaft position (CKP) sensor or its relationship with the crankshaft reluctor wheel |
