GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2006 🢒 GTO 🢒 Vehicle Control Systems 🢒 Computer/Integrating Systems 🢒 Scan Tool Does Not Communicate with UART Device

Circuit Description

The UART protocol utilizes a single wire bi-directional data line used to exchange information between the modules.

The following modules are connected to the serial data circuit:

    • Powertrain interface module (PIM)
    • Body control module (BCM)
    • Instrument panel cluster (IPC)
    • Electronic brake control module (EBCM)
    • Sensing and diagnostic module (SDM)
    • Radio

Step

Action

Yes

No

Schematic Reference: Data Link Connector Schematics

Connector End View Reference: Computer/Integrating Systems Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Refer to Diagnostic System Check - Vehicle .

2
  1. Connect the scan tool to the DLC.
  2. Turn ON the ignition, with the engine OFF.
  3. Attempt to communicate with each module on the serial data circuit:
    4. • Powertrain interface module (PIM)
    • Body control module (BCM)
    • Instrument panel cluster (IPC)
    • Electronic brake control module (EBCM)
    • Sensing and diagnostic module (SDM)
    • Radio

Does the scan tool communicate with all the modules on the serial data circuit?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3
  1. Disconnect the scan tool from the DLC.
  2. Disconnect all non-communicating modules on the serial data circuit.
  3. Test the serial data circuit between the DLC and all the modules on the serial data circuit, for the following conditions:
    4. • An open
    • A short to ground
    • A short to voltage

Did you find and correct the condition?

Go to Step 7

Go to Step 4

4

Test the following circuits of the module that is not communicating for an open or high resistance:

    • The battery positive voltage input circuits
    • The battery positive voltage output circuits
    • The ignition voltage input circuits
    • The ignition voltage output circuits
    • The switched battery positive voltage supply circuits
    • The ground circuits

Did you find and correct the condition?

Go to Step 7

Go to Step 5

5

Inspect for poor connections and terminal tension at the following harness connector circuits, of the module that is not communicating :

    • The battery positive voltage input circuits
    • The battery positive voltage output circuits
    • The ignition voltage input circuits
    • The ignition voltage output circuits
    • The switched battery positive voltage supply circuits
    • The ground circuits
    • The serial data circuits

Did you find and correct the condition?

Go to Step 7

Go to Step 6

6

Important: Perform the programming or set up procedure for the module if required, after it is replaced.

Replace the module that is not communicating on the serial data circuit. Refer to the applicable replacement procedure.

Did you complete the replacement?

Go to Step 7

--

7
  1. Connect all modules and connectors.
  2. Connect the scan tool to the DLC.
  3. Turn ON the ignition, with the engine OFF.
  4. Perform the Diagnostic System Check for the system exhibiting symptoms.

Did you complete the operation?

System OK

Go to Step 2