Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Power Window Schematics | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Verify that the all power windows inoperative fault is present. Do the power windows operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | With the ignition ON, are the power window switch green indicator LEDs illuminated? | Go to Step 11 | Go to Step 4 |
4 |
Does the test lamp illuminate? | Go to Step 10 | Go to Step 5 |
5 | Probe the power window switch side of the power window relay contacts with a test lamp. Does the test lamp illuminate? | Go to Step 16 | Go to Step 6 |
6 | Probe the power window relay coil and switch battery feed circuits with a test lamp. Does the test lamp illuminate? | Go to Step 7 | Go to Step 15 |
7 |
With the ignition ON, are the master window switch green indicator LEDs illuminated? | Go to Step 8 | Go to Step 17 |
8 | Using a fused jumper wire, jumper the relay coil control circuit at the body control module (BCM) to ground. With the ignition ON, are the master window switch green indicator LEDs illuminated? | Go to Step 9 | Go to Step 14 |
9 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 19 | Go to Step 18 |
10 | Inspect for poor connections at the harness connector of the driver window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 19 | Go to Step 13 |
11 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 19 | Go to Step 12 |
12 | Inspect for poor connections at the harness connector of the driver window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 19 | Go to Step 18 |
13 | Repair the open in the ground circuit of the power window switch. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 19 | -- |
14 | Repair and open in the power window relay control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 19 | -- |
15 | Repair the open in the battery positive feed circuits to the power window relay. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 19 | -- |
16 | Repair the open in the battery positive feed circuit between the relay and the power window switch. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 19 | -- |
17 | Replace the power window relay. Did you complete the repair? | Go to Step 19 | -- |
18 | Replace the BCM. Did you complete the repair? | Go to Step 19 | -- |
19 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
