GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2006 🢒 GTO 🢒 Body 🢒 Wiring Systems 🢒 Rear Wheel Speed Sensor Replacement

Removal Procedure

    Object Number: 1310264 Size: SH
  1. Remove the electrical connector (2) from the connector retaining clip (3).
  2. Disconnect the wheel speed sensor electrical connector (2).
  3. Remove the wheel speed sensor retaining bolt and remove the wheel speed sensor (1) from the differential cover.

Installation Procedure

    Object Number: 1310264 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the wheel speed sensor (1) to the differential cover. Secure with 1 bolt.

    2. Tighten
    Tighten the rear wheel speed sensor bolt to 10N·m (88.5 lb in).

  2. Connect the wheel speed sensor electrical connector (2).
  3. Install the wheel speed sensor electrical connector (2) into the connector retaining clip (3).
  4. Perform Diagnostic System Check - Vehicle .