REVISED QUARTER WINDOW MODULE REPLACEMENT PROCEDURE

SUBJECT: REVISED QUARTER WINDOW MODULE REPLACEMENT PROCEDURES

VEHICLES AFFECTED: 1985 THROUGH 1988 N-CAR

A new procedure has been developed for modular quarter window installation to prevent itching noise and paint damage. A tape has been released, Part Number 12393610, to provide the required clearance of the module to the body. This tape is to be added to the module prior to installation.

It is also recommended that no urethane solvents or solvent cleaners be used on the window module as they could cause cracking or crazing of the plastic module.

When removal or replacement of the quarter window module is required for any reason, the following installation procedure must be used.

REMOVAL:

------- Remove the quarter window module as described in the 1988 Body Service Manual.

CLEANING:

-------- DO NOT USE SOLVENTS of any kind on the plastic module material. Trim off any loose urethane material to prepare the module for installation.

INSTALLATION:

------------ 1. Prime the quarter window glass molding and/or frame with black primer in Urethane Adhesive Kit 9636067 or equivalent. Allow the primer to dry five minutes.

2. Apply tape, Part Number 12393610, to the inside surface of the outer flange of the window module for the entire periphery of the module and cut off the excess. DO NOT REMOVE THE CLEAR LINER OF THE TAPE. (Figure 1)

3. Apply a 4.8mm (3/16") bead of urethane as shown. (Figure 2 )

4. Remove the tape from the body, around the quarter window opening.

5. Install the quarter window module into the body opening.

6. Install molding, insert or applique.

7. Tape the entire assembly to the body until the urethane cures (6 hours).

8. Clean the body and glass using soap and water. Peel any excess urethane off after it has dried. DO NOT USE SOLVENT.

WARRANTY INFORMATION

Use the most applicable labour operation from the Canadian Labour, Time Guide and claim 0.5 hours.

Labor Time: 1.5 Hrs. per side

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.