GM Service Manual Online
For 1990-2009 cars only

Object Number: 399506  Size: MF
Body Control Module Components
Body Control System Schematics

Circuit Description

DTC B2648 (both current and history) indicates a short to battery in the ambient light sensor signal circuit.

Conditions for Setting the DTC

All of the following conditions must be met:

    • The Automatic Lighting Control (ALC) option is enabled.
    • Ignition 1 is active.
    • The ambient light sensor analog input is shorted to B+ for 5 seconds.

Action Taken When the DTC Sets

    • Stores DTC B2648 in the body control module (BCM) memory.
    • The SERVICE VEHICLE SOON indicator illuminate.
    • The check gauges chime sounds.

Conditions for Clearing the DTC

    • The BCM goes to sleep and reinitializes with the fault cleared.
    • All BCM history codes clear after 100 ignition cycles (from OFF to ON) with no current codes active.
    • Clear history and current DTCs using a Scan Tool scan tool.

Diagnostic Aids

If the DTC is a history DTC the problem may be intermittent. Perform the above tests while wiggling the wiring and connectors. This may often cause the malfunction to appear.

Test Description

The numbers below refer to the step numbers in the diagnostic table.

  1. This step determines a short to battery in CKT 1138 between the Body Control Module (BCM) and the Ambient Light Sensor.

Step

Action

Value(s)

Yes

No

Important: A short to ground will cause an open fuse(s). Before performing this diagnostic procedure, inspect the fuse(s) for an open.

1

Was the Body Control Module (BCM) System Check performed?

--

Go to Step 2

Go to Body Control Module System Check

2

  1. Disconnect the Ambient Light Sensor.
  2. Disconnect the BCM connector C2.
  3. Use the J 39200 DMM in order to measure the voltage in CKT 1138 between the Ambient Light Sensor connector terminal B and ground.

Is the measured resistance equal to the specified value?

0V

Go to Step 4

Go to Step 3

3

Repair the short to B+ in CKT 1138 between the Ambient Light Sensor connector terminal B and the BCM connector C2 terminal A3. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Step 5

--

4

Replace the ambient light sensor.

Is the repair complete?

--

Go to Step 5

--

5

  1. Reconnect all disconnected components.
  2. Clear the DTCs from memory.

Did DTC B2648 clear from memory?

--

Go to Step 7

Go to Step 6

6

Replace the BCM. Refer to the following procedures:

    • Body Control Module (BCM) Replacement

Is the repair complete?

--

Go to Step 7

--

7

Clear the DTCs from memory.

Are the DTCs cleared from memory?

--

Go to Body Control Module System Check

--