Step
| Action
| Normal Result(s)
| Abnormal Result(s)*
|
1
| Inspect the master cylinder fluid level.
| The master cylinder fluid level
is between ADD and FULL.
| Fill the Master Cylinder Reservoir if needed. Refer to
Master Cylinder Reservoir Filling
.
|
2
|
- Turn ignition OFF.
- Ensure that the Park brake is not applied.
- Start the engine.
| The
brake warning indicator illuminates briefly then turns off.
|
|
3
| With the vehicle in PARK, perform Brake Pedal Travel Test. Refer to
Brake Pedal Travel
.
|
| • | The brake pedal moves steadily towards floor, approximately 2-3 in. |
| • | The brake pedal stops and is firm against the pressure. |
|
|
4
| Release the brake pedal.
| The brake pedal returns to normal height.
|
Brake System Slow Release
|
5
|
- Press the brake pedal.
- Shift the vehicle into DRIVE.
- Perform Brake System Test. Refer to
Brake System Testing
.
|
| • | Braking action starts after applying the brakes. |
| • | The brakes do not grab - brake pedal does not vibrate. |
| • | The vehicle stops without excessive pedal effort. |
| • | The vehicle stops without pulling to one side. |
| • | The front and rear brakes apply evenly. |
| • | The vehicle stops without noise coming from the brakes. |
| • | The vehicle stops without noise coming from the vacuum booster. |
| • | The brakes do not drag after releasing the brake pedal. |
| • | The brakes do not make noise while driving. |
|
|
* Refer to the appropriate symptom diagnostic table for
the applicable abnormal result.
|
