Removal Procedure
- Raise and support the
vehicle on a suitable hoist. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Remove the front wheel speed sensor harness connector (5) from
the front wheel speed sensor.
- Remove the front wheel
speed sensor harness attaching clips (2) from the control arm and the frame.
- Cut the front wheel speed sensor wiring circuits within the main
engine harness.
- Strip the insulation on the engine harness leads and the new wheel
speed sensor harness leads.
Installation Procedure
- Splice the sleeve provided
in the harness kit over each engine harness lead.
- Install the new front wheel speed sensor harness leads to the
engine harness leads and crimp the connections. Make sure the wire colors
match.
- Heat shrink the tube lightly to seal the connection.
- Install the front wheel speed sensor harness attaching clips (2)
to the control arm and the frame.
- Install the front wheel
speed sensor harness connector (5) to the front wheel speed sensor.
- Lower the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Perform the
Diagnostic System Check - ABS
.