Removal Procedure
- Close the sunroof.
- Remove the sunroof opening trim lace. Refer to
Sunroof Opening Trim Finish Lace Replacement
.
- Remove the sunroof sunshade. Refer to
Sunroof Sunshade Replacement
.
- Remove the headlining trim finish panel. Refer to
Headlining Trim Panel Replacement
in Interior Trim.
| • | Disconnect the sunroof control switch |
| • | Disconnect the dome lamp |
- Disconnect the drain hose connections from the sunroof housing.
- Support the module when
removing the bolts in order to prevent the module from falling.
- Remove the sunroof module bolts (2).
- Pull the module downward at the rear mounting points in order
to disconnect the snap in the fasteners. Remove the snap in the fasteners
and discard the fasteners.
- Remove the sunroof module (1).
Installation Procedure
- Install the sunroof module (1).
Align the locating holes in the front of the module to the locating pins off
the roof.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the sunroof
module bolts (2).
Tighten
Tighten the sunroof module bolts to 11 N·m(97 lb in).
- Connect the drain hose connections to the sunroof housing.
- Install the headlining trim finish panel. Refer to
Headlining Trim Panel Replacement
in Interior Trim.
| • | Connect the sunroof control switch |
- Install the sunroof sunshade. Refer to
Sunroof Sunshade Replacement
.
- Install the sunroof opening trim lace. Refer to
Sunroof Opening Trim Finish Lace Replacement
.
