Subject: | Revised Transmitter Programming Procedure |
Models: | 2000 Chevrolet Malibu |
This bulletin is being issued to revise the Transmitter
Programming Procedure in the Keyless Entry sub-section of Body & Accessories
in the Service Manual.
Please use the following to replace the existing information in the
Service Manual.
Important: Once the remote control door lock receiver enters the programming/diagnostic
mode, the programming of the first transmitter erases all previous transmitter
programming information. You must then program all of the transmitters.
Do not operate or program the transmitters in the vicinity of other
vehicles that are in the keyless entry programming/diagnostic mode. This prevents
the programming of the transmitters to the incorrect vehicle.
Up to 4 transmitters may be programmed.
Transmitter Programming Procedure (Method 1 - No Tools Required)
To program the transmitters, perform the following procedure while seated
in the vehicle driver's seat:
- Close all the vehicle doors.
- Remove the ignition key from the ignition lock cylinder.
- Press and hold unlock on the door lock switch.
Important: To successfully enter the keyless entry programming/diagnostic mode,
steps 4 through 6 must be completed within 25 seconds of pressing the
door unlock switch.
- While holding the door lock switch in the unlock position, insert
and remove the ignition key twice. Do not rotate the ignition lock cylinder.
- Insert the ignition key a third time leaving the key in the ignition
lock cylinder. The ignition must remain in the LOCK position for the rest
of the procedure.
- Release the door lock switch. The chime will sound three chimes
to signal that transmitter programming/diagnostic mode is active.
- Press and hold the lock and unlock buttons at the same time on
the keyless entry transmitter for approximately 4 seconds. The chime
will sound two times to signal that the transmitter has been programmed successfully.
- Repeat step 7 for the rest of the transmitters (for a total of
4 transmitters).
- To exit the transmitter programming/diagnostic mode, perform either
of the following:
• | Turn the ignition switch to the RUN position. |
• | Remove the ignition key from the ignition switch. |
Transmitter Programming Procedure (Method 2 - Scan Tool Required)
Perform the following steps in order to program the remote control door
lock transmitters to the remote control door lock receiver using the scan
tool:
- Install a scan tool.
- Turn the ignition ON, with the engine OFF.
- Use the scan tool in order to access the Body Control Module (BCM)
Special Function: Program Key Fobs menu.
- Follow the directions on the scan tool in order to program the
transmitters.
- Operate the transmitter functions in order to verify correct system
operation. Refer to Keyless Entry System Operation.