GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

Schematic Reference: Steering Wheel Controls Schematics

1

Did you perform the Radio/Audio System Diagnostic System Check?

--

Go to Step  2

Go to Diagnostic System Check - Radio/Audio System

2

  1. Turn ON the ignition, with the engine OFF.
  2. Turn ON the radio.
  3. Operate all of the steering wheel controls.

Do all of the steering wheel controls operate properly?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step  3

3

Caution: When you are performing service on or near the SIR components or the SIR wiring, you must disable the SIR system. Refer to Disabling the SIR System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.

  1. Turn OFF the ignition.
  2. Disable the SIR. Refer to Disabling the SIR System in SIR.
  3. Disconnect the steering wheel controls, steering column in-line connector.
  4. Measure the resistance from the radio on signal circuit of the steering wheel controls to the remote radio control signal circuit of the steering wheel controls.
  5. Press the following steering wheel controls and record the resistance values:

Do the recorded resistances measure near the specified values?

Volume Up--1270 ohms

Volume Down--1564 ohms

Play--1912 ohms

Mute--2387 ohms

Seek Up--3102 ohms

Seek Down--4282 ohms

AM/FM--6652 ohms

Pre-Set--13,580 ohms

Go to Step 4

Go to Step  6

4

Test the radio on signal circuit between the radio and steering wheel controls for an open, short to ground, or short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step  10

Go to Step  5

5

Test the remote radio control signal circuit between the radio and steering wheel controls for an open, short to ground, or a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step  10

Go to Step  7

6

Inspect for poor connections at the harness connector of the steering wheel controls. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step  10

Go to Step  8

7

Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step  10

Go to Step  9

8

Replace the steering wheel controls.

Did you complete the replacement?

--

Go to Step  10

--

9

Important:: Perform the set up procedure for the radio.

Replace the radio. Refer to Radio Replacement and Radio Setup for service procedure.

Did you complete the replacement?

--

Go to Step  10

--

10

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

--