Hazard Warning Switch Replacement Pontiac

1. Remove the Instrument panel (IP) accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.



2. Remove the bracket screws from the IP accessory switch mounting plate.



3. Remove the bracket.



4. Use a small flat-bladed tool in order to depress and release the hazard warning switch retainers. Press the switch out with your thumb.



5. Remove the hazard warning switch.

1. Position the hazard warning switch to the bracket.



2. Install the switch to the bracket by pressing into place until fully seated.



3. Position the bracket to the IP accessory trim plate.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the mounting plate bracket screws to the IP accessory switch.

Tighten
Tighten the screws to 3 N·m (27 lb in).

5. Install the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.