DUAL CAPACITY ACC. PUMP INOP MISSING WIRE CORRECTION

VEHICLES AFFECTED: 1986 Pontiac 'G' Models Built Before VIN G2265411 With (LG4) 5.0L Engine and (NM5) Canadian Emissions

Some 1986 Pontiac 'G' models built before VIN G2265411 with (LG4) 5.0L engine and (NM5) Canadian Emissions may have an inoperative dual capacity accelerator pump solenoid due to a wire missing from cavity 'A5' of the instrument panel wiring harness bulkhead connector (Figure 1).

To repair this condition it will be necessary to make and install a jumper wire from the 'ignition 1' cavity in front of the fuse block (Figure 2) to cavity 'A5' (Figure 1) of the bulkhead connector.

The jumper wire should consist of:

1 - 12004892 Connector Body 1 - 8917928 Terminal 1 - 12034046 Terminal 30CM - No. 8 Ga. Black Wire

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.