Removal Procedure
- Disconnect the negative
battery cable. Refer to
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
in Caution and Notices. - Remove the serpentine drive belt.
- Refer to Power Steering Pump Replacement for removal of power steering pump assembly.
- Remove the electrical connector.
- Remove the bolt.
- Remove the sensor.
Installation Procedure
- Install the camshaft Position Sensor.
- Install the electrical connector.
- Install the power steering pump.
- Install the serpentine drive belt.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the retaining bolt to 10 N·m (8 lb ft).
