Wheel Speed Sensor Replacement Front
Removal Procedure
Important: The front wheel speed sensors and rings are integral with the hub and
bearing assemblies.
If a speed sensor or a ring needs replacement, replace the entire hub
and bearing assembly. Do not service the harness pigtail individually because
the harness pigtail is part of the sensor. Refer to
Front Wheel Drive Shaft Bearing Replacement
Front Suspension.
- Raise and support the vehicle on a suitable hoist. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Remove the front tire and wheel assembly. Refer to
Wheel Removal
in Tires and Wheels.
- Remove the front wheel
speed sensor electrical connector (2).
- Remove the hub and bearing
assembly (2). Refer to
Front Wheel Drive Shaft Bearing Replacement
Front
Suspension.
Installation Procedure
- Install the hub and bearing
assembly (2) to the vehicle. Refer to
Front Wheel Drive Shaft Bearing Replacement
Front
Suspension.
- Install the front wheel
speed sensor electrical connector (2).
- Install the wheel and tire assembly. Refer to
Wheel Installation
in Tires and Wheels.
- Lower the vehicle.
- Turn the ignition switch to the RUN position with the engine off.
- Perform the
Diagnostic System Check
Wheel Speed Sensor Replacement Rear
Important: The rear wheel speed sensors and rings are integral with the hub and
bearing assemblies.
If a speed sensor or a ring needs replacement, replace the entire hub
and bearing assembly. Refer to
Rear Wheel Bearing and Hub Replacement
in
Rear Suspension.