Name | Location | Locator View | Connector End View |
|---|---|---|---|
A/C Compressor Clutch Coil | Part of the A/C compressor, on the lower right front of the engine | ||
A/C Refrigerant Pressure Sensor | Left side of the engine compartment on the accumulator | ||
Blower Motor | Behind the right side of the IP, in the right side of the heater-A/C control module | -- | |
Blower Motor Control Module | Behind the right side of the IP, in the right side of the heater-A/C control | ||
Blower Motor Resistor | Behind the right side of the IP, in the right side of the heater-A/C control module | ||
Data Link Connector (DLC) | On the bottom of the IP, right of the steering column | Data Link Communications Component Views in Wiring Systems | Data Link Communications Connector End Views in Wiring Systems |
Fuse Block | Right side of the IP, in the IP compartment opening | Power and Grounding Component Views in Wiring Systems | -- |
Heater-A/C Control (C60) | Center of the IP | ||
Inside Air Temperature Sensor | Behind the left side of the IP, on the right side of the instrument cluster | ||
Left Electric Actuator (C60) | Left side of the heater-A/C control module | ||
Right Electric Actuator | Right side of the heater-A/C module | ||
Underhood Accessory Wiring Junction Block | Right side of the engine compartment, mounted to the strut tower | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Vacuum/Electric Solenoid | Behind the right side of IP, right of the blower motor | ||
C101 (20 cavities) | IP wiring harness to the engine wiring harness, on the left side of the engine compartment on the front of the strut tower | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
C120 (2 cavities) | IP wiring harness to the forward lamp wiring harness, on the right side of the engine compartment, rear of the battery | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
C200 (56 cavities) | IP wiring harness to the body wiring harness, behind the right side of the IP, near the shroud | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
C252 (1 cavity) | IP wiring harness interconnect, behind the heater control | Harness Routing Views in Wiring Systems | -- |
G100 | Right side of the engine compartment, at the base of the battery | Power and Grounding Component Views in Wiring Systems | -- |
G111 (VIN K & VIN 1) | Right side of the engine on the ignition control module bracket | Power and Grounding Component Views in Wiring Systems | -- |
G111 (VIN M) | Lower left front of the engine on the transaxle stud, near the starter | Power and Grounding Component Views in Wiring Systems | -- |
G113 | Lower left front of the engine on the transaxle stud, near the starter | Power and Grounding Component Views in Wiring Systems | -- |
G117 (VIN K & VIN 1) | Lower left front of the engine on transaxle stud, near the starter | Harness Routing Views in Wiring Systems | -- |
G117 (VIN M) | Lower left front of the engine on the transaxle stud, above the starter | Power and Grounding Component Views in Wiring Systems | -- |
G200 | Right side of the IP cross beam, behind the fuse block | Power and Grounding Component Views in Wiring Systems | -- |
P100 | Lower right side of the dash panel | Harness Routing Views in Wiring Systems | -- |
P101 | Upper left side of the dash panel | Harness Routing Views in Wiring Systems | -- |
S105 | Engine wiring harness, in the front of the engine compartment, approximately 4 cm (2 in) from the C105 (engine coolant fan jumper connector) breakout | Harness Routing Views in Wiring Systems | -- |
S202 | IP harness, behind the center of the IP, approximately 17 cm (7 in) from the data link connector breakout | Harness Routing Views in Wiring Systems | -- |
S206 | IP wiring harness, right side of the steering column, approximately 4 cm (2 in) from the data link connector breakout | Harness Routing Views in Wiring Systems | -- |
S211 | IP wiring harness, behind the center of the IP, approximately 11 cm (4 in) from the data link connector | Harness Routing Views in Wiring Systems | -- |
S213 | IP wiring harness, approximately 4 cm (2 in) from the blower motor resistors/control module breakout | Harness Routing Views in Wiring Systems | -- |
S221 | IP wiring harness, right side of the steering column, approximately 17 cm (7 in) from the data link connector breakout | Harness Routing Views in Wiring Systems | -- |
S237 | IP wiring harness, behind the center of IP, approximately 30 cm (12 in) from the data link connector breakout | Harness Routing Views in Wiring Systems | -- |
S238 | IP wiring harness, below the center of the IP, approximately 27 cm (11 in) from C240 | Harness Routing Views in Wiring Systems | -- |
S245 | IP wiring harness, behind the center of IP, approximately 43 cm (17 in) from the data link connector breakout | Harness Routing Views in Wiring Systems | -- |
S258 | IP wiring harness, behind the center of IP, approximately 37 cm (15 in) from the data link connector breakout | Harness Routing Views in Wiring Systems | -- |
