Check the DIC/HVAC fuse in the fuse block.

Is the DIC/HVAC fuse open?

--

Go to Step 2

Go to Step 3

Locate and repair a short to ground in circuit 41 (BRN).

Is the repair complete?

--

System OK

--

1. Place the ignition switch in the on position.
2. Connect a test lamp between the HVAC Control module harness connector C 1 terminal B and ground.

Does the test lamp light?

--

Go to Step 5

Go to Step 4

Locate and repair a poor connection or an open in circuit 41 (BRN).

Is the repair complete?

--

System OK

--

1. Place the heater A/C blower control in the OFF position.
2. Connect a test lamp between the heater A/C control connector C 2 terminal A and ground.

Does the test lamp light?

Go to Step 8

Go to Step 6

Check for a poor connection or an open in circuit 119 (WHT) between the heater A/C control connector C 2 terminal A and connector C 1 terminal A.

Is there a poor connection or open in the circuit?

--

Go to Step 7

Go to Step 9

Repair the fault in circuit 119 (WHT).

Is the repair complete?

--

System OK

--

1. Place the mode selector in the HEAT position.
2. Turn the blower ON.
3. Determine if the air is flowing from the floor outlets.

Is the air flowing from the floor outlets?

--

System OK

Go to Vacuum System

Replace the heater-A/C control. Refer to Control Assembly Replacement .

Is the repair complete?

--

System OK

--