Refer to repair procedures in Electrical Diagnosis for
information on the following:
| • | Other diagnostic information |
Most lighting problems are caused by the following conditions:
You can repair many of these problems by replacing a part that requires
a special procedure (such as a lens and a housing which are sealed together).
For these repairs, follow the instructions which are normally included in
the replacement parts package.
When you remove a component that requires special sealing items (such
as sealing washers), reinstall those items when you replace the component.
If any body sealing items (such as grommets) are disturbed, repair them
in order to keep the passenger compartment properly sealed.
Use the following general guidelines in order to diagnose lighting system
problems:
- Verify the owner's problem.
- Attempt to operate other systems which are powered through the
same fuse. If these other systems are inoperative, replace the fuse. Refer
to Fuse Block Details in Electrical Diagnosis for fuse applications.
- Test for aftermarket equipment. If you discover add-on accessories,
disconnect the system in order to verify that the add-on's installation is
not the cause of the problem.
- Test all of the connectors and all of the wiring which is related
to the suspected electrical component. Test for the following conditions:
| • | Poor mating of connector halves |
| • | Terminals which are not fully seated in the connector body (backed-out) |
| • | Dirt or corrosion on the connector terminals, which could impede
proper terminal contact |
- Test all related ground eyelets for a clean and a tight connection.
If you are still unable to correct the problem, refer to Troubleshooting
procedures in Electrical Diagnosis.
