Step
| Action
| Value(s)
| Yes
| No
|
DEFINITION: None of the interior lights turn on when a door is open,
IP dimmer switch is in the DOME position, or any of the interior lighting
modes is active.
|
1
| Was the Interior Lamps System Check performed?
| --
| Go to
Step 2
| Go to
Interior Lamps System Check
|
2
| Was the BCM Diagnostic System Check performed?
| --
| Go to
Step 3
| Go to
Diagnostic System Check - Body Control System
in Body Control System
|
3
|
- Turn the ignition switch from the OFF position to the RUN position.
- Turn the IP dimmer switch to the DOME position.
- Using a test light, probe between the BCM connector C1
terminal E and ground.
Does the test light illuminate?
| --
| Go to
Step
4
| Go to
Step 5
|
4
| Repair a poor connection or open in circuit 1393.
Is the repair complete?
| --
| Go to
Step
6
| --
|
5
|
- Inspect the BCM connector C1 terminal E for poor
terminal contact. Perform repairs as needed.
- If the terminal contact is OK, replace the BCM. Refer to
Body Control Module Replacement
in Body Control System.
Is the repair complete?
| --
| Go to
Step
6
| --
|
6
|
- Turn the ignition switch to the OFF position.
- Reconnect the connectors and reinstall the components that were
removed.
- Turn the ignition switch to the RUN position for 6 seconds.
- Turn the ignition switch to the OFF position.
- Remove the MALL fuse.
- Turn the ignition switch to the ACC position. (The BCM sounds
the chime a number of times equivalent to the BCM type installed on the vehicle.)
- Within 1 second, turn the ignition switch from the ACC
position, to the OFF position, then back to the ACC position. (The BCM sounds
any DTCs stored.)
Are there any BCM DTCs present?
| --
| Go to
Diagnostic System Check - Body Control System
in Body Control System
| Go to
Interior Lamps System Check
|
