Removal Procedure
- Raise and support the
vehicle on a suitable hoist. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Disconnect the front wheel speed sensor jumper harness connector
from the ABS harness connector (1).
- Remove the front wheel speed sensor jumper harness
(2) from the control arm retaining clips (3).
- Disconnect the front wheel
speed jumper harness connector (1) from the front wheel speed sensor connector
(3).
- Remove the front wheel speed sensor jumper harness (2) from the
vehicle.
Installation Procedure
- Connect the front wheel
speed sensor jumper harness connector (1) to the front wheel speed sensor
connector (3).
- Install the front wheel
speed sensor jumper harness (2) to control arm retaining clips (3).
- Connect the front wheel speed sensor jumper harness connector
to the ABS harness connector (1).
- Lower the vehicle.
- Turn the ignition switch to the RUN position, with the engine
off.
- Perform the
Diagnostic System Check - ABS