Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Remote Keyless Entry System Check? | -- | Go to Step 2 | |
2 | Did you perform the BCM Diagnostic System Check? | -- | Go to Step 3 | Go to Diagnostic System Check - Body Control System in Body Control System |
3 |
Does the rear compartment lid open? | -- | Go to Step 4 | Go to Rear Compartment Lid Release System Check in Body Rear End |
4 |
Does the rear compartment lid open? | -- | Go to Step 10 | Go to Step 5 |
5 |
Does the rear compartment lid open? | - | Go to Step 11 | Go to Step 6 |
6 |
Does the test lamp illuminate? | -- | Go to Step 7 | Go to Step 12 |
7 | Connect a test lamp between the rear compartment lid release relay harness connector terminal C1 and ground. Does the test lamp illuminate? | -- | Go to Step 8 | Go to Step 12 |
8 | Use a 20A fused jumper to connect between the rear compartment lid release relay harness connector terminal A2 and terminal C1. Does the rear compartment lid open? | -- | Go to Step 9 | Go to Step 13 |
9 | Use a DMM to measure the resistance between the RCDLR harness connector terminal H and the rear compartment lid release relay harness connector terminal C2. Is the resistance within the specified range? | Less than 2 ohms | Go to Step 14 | Go to Step 15 |
10 | Replace the defective transmitter. Did you complete the repair? | -- | Go to Step 16 | -- |
11 |
Did you complete the repair? | -- | Go to Step 16 | -- |
12 | Repair a poor connection or open in circuit 275. Did you complete the repair? | -- | Go to Step 16 | -- |
13 | Repair a poor connection or an open in circuit 56. Did you complete the repair? | -- | Go to Step 16 | -- |
14 | Replace the rear compartment lid release relay. Did you complete the repair? | -- | Go to Step 16 | -- |
15 | Repair a poor connection or an open in circuit 253. Did you complete the repair? | -- | Go to Step 16 | -- |
16 | Operate the keyless entry system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
