Tools Required

J 24319-B Universal Steering Linkage Puller

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.



3. Remove the prevailing torque nut (2) from the outer tie rod assembly (1).



4. Loosen the jam nut (2) on the inner tie rod assembly (1).

Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.




5. Using the J 24319-B remove the outer tie rod assembly from the steering knuckle.



6. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

1. Install the outer tie rod assembly (3) to the inner tie rod assembly (1).
2. Do not tighten the jam nut (2).



3. Install the outer tie rod assembly (2) to the steering knuckle (1).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the prevailing torque nut (2) to the outer tie rod assembly (1).

Tighten
Tighten the prevailing torque nut (2) to 30 N·m (22 lb ft). Tighten the prevailing torque nut (2) an additional 120 degrees of rotation. Inspect to ensure that 2½ - 4½ threads are visible above the nylon washer.




5. Tighten the jam nut (2) against the outer tie rod assembly (3).

Tighten
Tighten the jam nut to 70 N·m (52 lb ft).

6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
7. Lower the vehicle.
8. Perform a front end alignment. Refer to Wheel Alignment Measurement in Wheel Alignment.