Removal Procedure
- Apply the park brake.
- Position the transaxle selector in the low range.
- Raise the front floor console armrest.
- Remove the front floor console storage compartment.
- Remove the mat from the
storage compartment.
- Open the console cup holder.
- Remove the console trim
plate, starting at the rear and pulling up, working forward in order to release
the retainers.
- Remove the console trim plate from the front floor console.
- Disconnect the electrical
connector from the driver's seat heater switch, if equipped.
Installation Procedure
- Connect the electrical
connectors to the driver's seat heater switch, if equipped.
- Install the trim plate
to the front floor console by pressing down firmly until fully seated.
- Reposition the transaxle selector into PARK.
- Close the console cup holder.
- Install the console storage compartment.
- Lower the console armrest.
- Install the console storage
compartment mat to the console storage compartment.
- Release the park brake.