Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Open the upper guide loop attachment cover of the front seat belt.
2. Remove the upper seat belt guide loop attachment nut.
3. Pull the door weatherstrip from the pinchweld flange as required.



4. Remove the upper trim panel from the center pillar using J 38778 .
5. Remove the upper trim panel from the vehicle.

1. Align the upper trim panel to the center pillar.
2. Press firmly on the upper trim panel until the retainers are fully seated.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the guide loop attachment nut.

Tighten
Tighten the guide loop attachment nut to 42 N·m (31 lb ft).

4. Close the upper guide loop attachment cover of the front seat belt.
5. Install the door weatherstrip to the pinchweld flange.