Circuit Description
The data link connector (DLC) provides operating power for the scan tool at terminal 16 for battery positive voltage, and at terminal 4 for ground. The scan tool will power up with the ignition off. The DLC provides the signal ground at terminal 5, class 2 serial data signal at terminal 2, UART serial data signal at terminal 9 and E and C serial data signal at terminal 14.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
The CIG LTR fuse supplies power to terminal 16 of the DLC.
-
The battery positive voltage and ground circuits of the DLC are functioning properly. The malfunction must be due to the scan tool.
Step | Action | Yes | No |
|---|---|---|---|
Test the battery positive voltage circuit of the DLC for an open or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Control Module References in Body Control System for the applicable Diagnostic System Check | Go to Step 2 | |
2 | Test the ground circuit at terminal 4 of the DLC for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Control Module References in Body Control System for the applicable Diagnostic System Check | Go to Step 3 |
3 | Inspect for poor connections at terminals 4 and 16 of the DLC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Control Module References in Body Control System for the applicable Diagnostic System Check | Go to Step 4 |
The scan tool may be malfunctioning. Refer to the scan tool user guide. Did you obtain a properly operating scan tool? | Go to Control Module References in Body Control System for the applicable Diagnostic System Check | -- |
