Tools Required

J 38185 Hose Clamp Pliers

1. Drain the cooling system. Refer to Cooling System Draining and Filling .
2. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement in Engine Controls - 3.1L.
3. Remove the left engine mount strut. Refer to Engine Mount Strut Replacement in Engine Mechanical - 3.1L.
4. Disconnect the left spark plug wires from the left spark plugs. Refer to Spark Plug Wire Replacement in Engine Controls - 3.1L.
5. Use the J 38185 in order to reposition the hose clamp from the water outlet housing.
6. Remove the radiator inlet hose from the water outlet housing.



7. Remove the heater outlet hose (2) from the thermostat bypass pipe.
8. Remove the throttle body inlet (3) and outlet (4) hoses from the thermostat bypass pipe.



9. Remove the thermostat bypass pipe nut.



10. Use the J 38185 in order to reposition the hose clamp from the thermostat bypass pipe.
11. Remove the thermostat bypass pipe hose.



12. Remove the thermostat bypass pipe bolt.
13. Remove the thermostat bypass pipe.

1. Install the thermostat bypass pipe.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the thermostat bypass pipe bolt.

Tighten
Tighten the thermostat bypass pipe bolt to 11 N·m (98 lb in).




3. Install the thermostat bypass pipe hose.
4. Use the J 38185 in order to reposition the hose clamp to the thermostat bypass pipe.



5. install the thermostat bypass pipe nut.

Tighten
Tighten the thermostat bypass pipe nut to 25 N·m (18 lb ft).




6. Install the heater outlet hose (2) to the thermostat bypass pipe.
7. Install the throttle body inlet (3) and outlet (4) hoses to the thermostat bypass pipe.



8. Install the radiator inlet hose to the water outlet housing.
9. Use the J 38185 in order to reposition and install the radiator inlet hose clamp to the water outlet housing.
10. Install the left spark plug wires to the left spark plugs. Refer to Spark Plug Wire Replacement in Engine Controls - 3.1L.
11. Install the left engine mount strut. Refer to Engine Mount Strut Replacement in Engine Mechanical - 3.1L.
12. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement in Engine Controls - 3.1L.
13. Fill the cooling system. Refer to Cooling System Draining and Filling .
14. Inspect for leaks.