GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 24319-B Universal Steering Linkage Puller

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

  3. Object Number: 575833  Size: SH
  4. Remove the prevailing torque nut (2) from the outer tie rod assembly (1).

  5. Object Number: 297349  Size: SH
  6. Loosen the jam nut (2) on the inner tie rod assembly (1).
  7. Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.


    Object Number: 643351  Size: SH
  8. Using the J 24319-B remove the outer tie rod assembly from the steering knuckle.

  9. Object Number: 297358  Size: SH
  10. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

Installation Procedure


    Object Number: 297355  Size: SH
  1. Install the outer tie rod assembly (3) to the inner tie rod assembly (1).
  2. Do not tighten the jam nut (2).

  3. Object Number: 297628  Size: SH
  4. Install the outer tie rod assembly (2) to the steering knuckle (1).

  5. Object Number: 575833  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the prevailing torque nut (2) to the outer tie rod assembly (1).
  7. Tighten
    Tighten the prevailing torque nut (2) to 30 N·m (22 lb ft). Tighten the prevailing torque nut (2) an additional 120 degrees of rotation. Inspect to ensure that 2½ - 4½ threads are visible above the nylon washer.


    Object Number: 297355  Size: SH
  8. Tighten the jam nut (2) against the outer tie rod assembly (3).
  9. Tighten
    Tighten the jam nut to 70 N·m (52 lb ft).

  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  11. Lower the vehicle.
  12. Perform a front end alignment. Refer to Wheel Alignment Measurement in Wheel Alignment.