For 1990-2009 cars only
- Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
- Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle .
- Remove the wire harness assembly (1) from the wire harness strap (2).
- Disconnect the turn signal and multifunction switch assembly connector from the inflatable restraint steering wheel module coil connector.
- Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
- Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
- Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury
In order to avoid the above conditions, observe the following guidelines:
• Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Remove the wire harness straps from the wire harness assembly (1) and the steering column.
