For 1990-2009 cars only
- Remove the left instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
- Press the brake pedal fully.
- Push the switches into the retainers until the switches are fully seated.
- Pull the brake pedal fully rearward against the pedal stop until the audible clicks can no longer be heard.
- Measure the brake pedal travel distances from the centerline of the brake pedal pad. Compare the measurements to the following values. The comparison of the values can verify that the cruise control release switch and the stoplamp switch are correctly adjusted:
- Install the left instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
Important: The cruise control release switch and the stoplamp switch are adjusted together. Incorrect adjustment of either of these switches may cause premature brake lining wear or the incorrect operation of the cruise control system.
| • | The cruise control release switch and the stoplamp switch contacts must actuate at 3.5-12.5 mm (0.125-0.500 in) of brake pedal travel. |
| • | Nominal actuation of the stop lamp switch contacts occurs about 4.5 mm (0.2 in) beyond the point of cruise control release switch actuation. |
