Tools Required

J 25070 Heat Gun

1. Use a J 25070 152 mm (6 in) from the surface to heat the molding.
2. Apply the heat for approximately 30 seconds using a circular motion.




Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

3. Use a small, plastic, flat-bladed tool to remove the door finish panel from the door surface.
4. Remove the door finish panel from the door.



5. Beginning at one end, pull the center pins from the door finish panel support retainers.
6. Remove the door finish panel support from the door.

1. Align the clips on the door finish panel support to the holes in the door.

Press the clips into the holes until fully seated.

2. Use Varnish Makers and Painters (VMP) naphtha to clean the body panel.
3. Use a heat lamp or J 25070 to warm the body panel to a minimum of 21°C (70°F), if necessary.



4. Install the bottom flange of the door finish panel into the support.
5. Install the locating pins into the door.

Important: Do not touch the adhesive backing.

6. Remove the backing from the door finish panel.
7. Push the door finish panel inward to ensure maximum bond to the body.