Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.

1. Turn the ignition switch to the OFF position.
2. Remove brake pressure modulator valve (BPMV) and electronic brake control module (EBCM) as an assembly from the BPMV bracket. Refer to Brake Pressure Modulator Valve Replacement .
3. Remove the 3 BPMV bracket nuts (1, 2, and 3) attaching the BPMV bracket (4) to the wheel housing.
4. Remove the BPMV bracket (4) from the vehicle.

1. Install the BPMV bracket (4) to the wheel house.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the 3 BPMV bracket nuts (1, 2, and 3) to the studs on the BPMV bracket (4).

Tighten
Tighten the 3 BPMV bracket nuts to 10 N·m (89 lb in).

3. Install the BPMV and EBCM as an assembly to the BPMV bracket. Refer to Brake Pressure Modulator Valve Replacement .
4. Turn the ignition switch to the RUN position.
5. Perform the Diagnostic System Check - Vehicle .