Sunroof Motor/Actuator Initialization/Teach Process New Motor
Perform the Initialization/Teach Process any time a new sunroof motor actuator is installed in the vehicle.
- Ensure that the electrical harness on the headliner is connected to the sunroof.
- Press the sunroof switch to the close position until the window stops at the front hard stop in the fully closed position, then moves slightly back to the soft stop position. Release the switch.
- Verify the operation of the sunroof.
Important: The Initialization/Teach Process is not complete if any of the following actions
take place before the initialization cycle is done:
• The sunroof switch is not held in the close position. • The ignition and/or battery power has been removed. • The glass panel has not reached the closed position.
Sunroof Motor/Actuator Initialization/Teach Process Existing Motor
Perform the Initialization/Teach Process any time the sunroof motor/actuator is removed from the sunroof.
- Ensure that the electrical harness on the headliner is connected to the sunroof.
- Press the sunroof switch to the close position until the window stops at the front soft stop in the fully closed position. Release the switch.
- Press the close position again. Hold the switch for at least 13 Seconds. The sunroof will stall at the hard stop, then move slightly back to the soft stop position. Release the switch.
- Verify the operation of the sunroof.
Important: The Initialization/Teach Process is not complete if any of the following actions
take place before the initialization cycle is done:
• The sunroof switch is not held in the close position. • The ignition and/or battery power has been removed. • The glass panel has not reached the closed position.
