Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Place the hazard switch to the ON position. Do the hazard lamps turn ON? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 |
Do the hazard lamps illuminate? | Go to Step 8 | Go to Step 4 |
4 | Using a test lamp connected to battery positive voltage, probe the ground circuit of the hazard switch. Does the test lamp illuminate? | Go to Step 5 | Go to Step 6 |
5 | Test the hazard warning switch signal circuit for an open, poor connection or a short to battery positive. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 9 | Go to Step 7 |
6 | Repair a poor connection, open or a short to battery positive voltage in the hazard warning switch ground circuit. Refer to Circuit Testing and Wiring Repairs . Did you complete the repair? | Go to Step 9 | -- |
7 | Replace the body control module (BCM). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 9 | -- |
8 | Replace the multifunction turn signal switch. Refer to Turn Signal Multifunction Switch Replacement . Is the repair complete? | Go to Step 6 | -- |
9 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
