The inflatable restraint sensing and diagnostic module (SDM) contains sensing devices that converts vehicle velocity changes to electrical signals. The SDM processes the generated electrical signals and compares them to values stored in memory. When the generated signals exceed the stored values, the SDM performs additional signal processing and compares the generated signals to signals stored in memory. When 2 of the generated signals exceed the stored values, the SDM will cause current to flow through the inflator modules, deploying the inflator modules, and causing DTC B0051 to set.

Ignition voltage is between 9-16 volts.

DTC B0051 is a latched code. You cannot clear a latched code. Replace the SDM after following the instructions.

Schematic Reference

SIR Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

SIR System Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. Ignition OFF, inspect the vehicle for signs of inflator module or pretensioner deployment. Verify that the vehicle does not show any signs of inflator deployment.

⇒	If the vehicle displays any signs of inflator deployment, refer to Repairs and Inspections Required After a Collision .

2. Verify DTC B0051 does not set.

⇒	If DTC B0051 is set then replace the SDM.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.