Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Pull the rear door weatherstrip from the pinchweld flange as required.
2. If the vehicle does not have a side curtain air bag, use J 38778 to disengage the retaining clips.
3. If the vehicle has a side curtain air bag perform the following procedure:

•	Use a flat-bladed tool to remove the screw button cover.

•	Remove the retaining screw.

•	Use J 38778 to disengage the retaining clip.

4. Remove the trim panel from the vehicle.



5. If damaged, drill out the rivet on the retaining clip (2).
6. Remove the retaining clip from the vehicle.

1. If removed, position the retaining clip in the vehicle.
2. Install the rivet (1) on the retaining clip (2).



3. Position the panel on the rear quarter.
4. Install the locator tab at the rear of the panel.
5. Press in on the sail panel to secure the retaining clips.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. If equipped, install the retaining screw.

Tighten
Tighten the screw to 2 N·m (18 lb in).

7. Press in to secure the screw button cover.