GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2004 🢒 Matiz 🢒 Restraints 🢒 SIR 🢒 DTC 011

DTC 011 for Pontiac Matiz 2004

Circuit Description

When the ignition switch is turned ON, the sensing and diagnostic module (SDM) will perform tests to diagnose any malfunctions within itself.

After passing these tests, the SDM will check the driver pretensioner circuit. The SDM allows a very small amount of current to flow through the driver pretensioner circuit. The SDM monitors the voltage during this check.

Conditions for Setting the DTC

The firing circuit is shorted to ground.

Step

Action

Values

Yes

No

Caution: Refer to Battery Disconnect Caution in the Preface section.

 

1
  1. Disconnect the negative battery cable.
  2. Wait 1 minute for the SDM capacitor to discharge.
  3. Visually inspect the supplemental inflatable restraints (SIR) wiring harness.

Is there any visible damage to the SIR harness?

--

Go to Step 2

Go to Step 3

2
  1. Replace the SIR wiring harness.
  2. Reconnect the negative battery cable.

Is the repair complete?

--

Go to Diagnostic System Check - SIR

--

3
  1. Disconnect the electrical connector from the driver seat belt pretensioner module.
  2. Disconnect the electrical connector at the SDM.

    3. The shorting bar at the disconnected SDM connector will create a complete circuit between the wires from the driver seat belt pretensioner module.

  3. Use an ohmmeter to check the continuity between ground and one of the terminals at the SDM side of the wiring harness connector for the driver seat belt pretensioner module. Refer to Diagnostic Illustration 17 in SIR Diagnostic Illustrations .

Is the resistance less than the specified value?

∞

Go to Step 2

Go to Step 4

4
  1. Replace the SDM.
  2. Reconnect the negative battery cable.
  3. Set the scan tool to CODE ERASE.
  4. Perform the diagnostic system check.

Does DTC 011 still show as a current fault?

--

Go to Step 5

System OK

5
  1. Replace the driver seat belt pretensioner module.
  2. Reconnect the negative battery cable.

Is the repair complete?

--

Go to Diagnostic System Check - SIR

--