GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2000 🢒 Montana 🢒 Body and Accessories 🢒 Doors 🢒 Power Door Locks Switch Unlock Function Inoperative - One

Power Door Locks Switch Unlock Function Inoperative - One Door Lock Switch

Step

Action

Value(s)

Yes

No

1

Did you review the operation and perform the necessary inspections?

--

Go to Step 2

Go to Symptoms

2
  1. Use a test lamp in order to probe between B+ and the inoperative door lock switch connector terminal D. Refer to Circuit Testing in Wiring Systems.
  2. Press the inoperative door lock switch to the unlock position.

Does the test lamp illuminate?

--

Go to Step 3

Go to Step 4

3

Repair a poor connection or open in circuit 194. Refer to Wiring Repairs or Connector Repairs in Wiring Systems.

Is the repair complete?

--

Go to Step 5

--

4

Replace the inoperative door lock switch. Refer to Door Trim Plate Replacement .

Is the repair complete?

--

Go to Step 5

--

5
  1. Turn the ignition switch to the LOCK position.
  2. Reinstall the connectors and components that were removed.
  3. Turn the ignition switch to the LOCK position.
  4. Remove the BCM PRGRM fuse.
  5. Turn the ignition switch to the ACC position. (The BCM sounds the chime a number of times equivalent to the BCM type installed on the vehicle).
  6. Turn the ignition switch from the ACC position, to the LOCK position, then back to the ACC position within 1 second. (The BCM sounds any DTCs stored).

Are there any BCM DTCs present?

--

Go to Diagnostic Trouble Code (DTC) List/Type in Body Control Systems

Go to Step 6

6

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2

Power Door Locks Switch Unlock Function Inoperative - One Key Cylinder Switch

Step

Action

Value(s)

Yes

No

1

Did you review the operation and perform the necessary inspections?

--

Go to Step 2

Go to Symptoms

2
  1. Use a test lamp in order to probe between B+ and the inoperative door lock cylinder switch connector terminal D (LF and RF) or B (liftgate).
  2. Press the inoperative door lock switch to the unlock position.

Does the test lamp illuminate?

--

Go to Step 3

Go to Step 4

3

Repair a poor connection or open in circuit 781. Refer to Wiring Repairs or Connector Repairs in Wiring Systems.

Is the repair complete?

--

Go to Step 5

--

4

Replace the inoperative door lock cylinder switch. Refer to Door Lock Cylinder Replacement .

Is the repair complete?

--

Go to Step 5

--

5
  1. Turn the ignition switch to the LOCK position.
  2. Reinstall the connectors and components that were removed.
  3. Turn the ignition switch to the LOCK position.
  4. Remove the BCM PRGRM fuse.
  5. Turn the ignition switch to the ACC position. (The BCM sounds the chime a number of times equivalent to the BCM type installed on the vehicle).
  6. Turn the ignition switch from the ACC position, to the LOCK position, then back to the ACC position within 1 second. (The BCM sounds any DTCs stored).

Are there any BCM DTCs present?

--

Go to Diagnostic Trouble Code (DTC) List/Type in Body Control Systems

Go to Step 6

6

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2