GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2004 🢒 Montana 🢒 DTC 🢒 DTC B2755 or B2760

Circuit Description

The memory select switch signal circuits are supplied 12 volts through a resistor and monitored within the memory seat module. When a memory select switch is pressed, the signal circuit is closed to ground and the signal circuit voltage is pulled low.

Conditions for Setting the DTC

A memory select switch input to the memory seat module is active for more than 30 seconds.

Action Taken When the DTC Sets
    • The memory seat module will ignore the switch input for which a current status DTC is set.
    • When the fault is no longer present a history status DTC will be stored, and switch operation will be restored.

Conditions for Clearing the DTC
    • The DTC will be current for as long as the fault is present.
    • When the fault is no longer present the DTC will be a history status code.
    • The history DTC will be cleared after 100 error free ignition cycles, or by using the scan tool clearing DTCs feature.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. Verify that the DTC is current or history by monitoring the switch status for which the code is set.

    2.

  2. Tests the memory select switch for an internal fault.

Step

Action

Yes

No

Schematic Reference: Memory Seats Schematics

Connector End View Reference: Power Seat Connector End Views

1

Did you perform the Power Seat System Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Power Seat Systems

2

  1. Install a scan tool.
  2. With a scan tool, observe the memory select switch parameter in the memory seat module Input/Output data list.

Does the scan tool display inactive?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

  1. Disconnect the memory select switch connector.
  2. With a scan tool, observe the memory select switch parameter.

Does the scan tool display inactive?

Go to Step 5

Go to Step 4

4

Test the switch signal circuit for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 6

5

Inspect and repair any damage to the memory select switch connector and terminals which may cause the condition. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 7

6

Inspect and repair any damage to the memory seat module connector and terminals which may cause the condition. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 8

7

Replace the memory select switch.

Did you complete the replacement?

Go to Step 9

--

8

Replace the memory seat module. Refer to Memory Seat Control Module Replacement .

Did you complete the replacement?

Go to Step 9

--

9
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the system in order to verify the repair.

Does the DTC reset?

Go to Step 2

System OK