GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2000 🢒 Montana Ext. 🢒 Body and Accessories 🢒 Wiring Systems 🢒 Accelerator Control Cable Replacement

Removal Procedure

    Object Number: 12826 Size: SH
  1. Remove the left instrument panel sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges, and Console.
  2. Disconnect the accelerator cable from the accelerator pedal.
  3. Squeeze the accelerator cable cover tangs and push the accelerator cable through the bulkhead.

    4. Object Number: 12831 Size: SH
  4. Remove the accelerator cable shield, if equipped.
  5. Disconnect the accelerator cable from the retaining clip.
  6. Disconnect the accelerator cable from the throttle body lever.
  7. Disconnect the accelerator cable from the accelerator cable bracket.

    8. Object Number: 50638 Size: SH
  8. Remove the accelerator cable from the vehicle. Note the cable routing for aid in installation.

Installation Procedure

    Object Number: 50638 Size: SH

    Notice: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

  1. Install accelerator cable into car using routing noted during removal.

    2. Object Number: 12826 Size: SH
  2. Install the snap retainer through the bulkhead.
  3. Connect the accelerator cable through the slot in the accelerator pedal lever.
  4. Seat the snap retainer in the accelerator pedal lever.

    5. Object Number: 12831 Size: SH
  5. Connect the accelerator cable to the throttle body lever.
  6. Connect the accelerator cable to the accelerator cable bracket.
  7. Connect the accelerator cable into the retaining clip.
  8. Reinstall the accelerator cable shield, if equipped.
  9. Inspect and check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.
  10. Reinstall the left instrument panel sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges, and Console.