GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2001 🢒 Montana Ext. 🢒 Body and Accessories 🢒 Body Control System 🢒 Theft Deterrent Module Replacement

Removal Procedure
  1. Remove the instrument panel (IP) knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  2. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle in Steering Wheel and Column.
  3. Remove the upper steering column shroud.
  4. Disconnect the electrical connector at the base of the steering column.

    5. Object Number: 473414 Size: SH
  5. Pull the PASS-Key® III module from the ignition lock cylinder housing.
  6. Remove the electrical connector and wires from the steering column.
  7. Remove the PASS-Key® III module from the vehicle.

Installation Procedure
  1. Install the PASS-Key® III module to the vehicle.
  2. Install the electrical connector and wires to the column.

    3. Object Number: 473414 Size: SH
  3. Slide the PASS-Key® III module over the ignition lock cylinder housing.
  4. Connect the electrical connector at the base to the steering column.
  5. Install the upper column shroud.
  6. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle in Steering Wheel and Column.
  7. Install the IP knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  8. Program the theft deterrent system. Refer to Programming Theft Deterrent System Components .