GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2002 🢒 Montana Ext. 🢒 General Information 🢒 General Information 🢒 Rear Wheel Bearing and Hub Replacement

Rear Wheel Bearing and Hub Replacement for Pontiac Montana Ext. 2002

Rear Wheel Bearing and Hub Replacement DiscBrake

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Inspect the ball joint. Refer to Ball Joint Inspection .
  4. Disconnect the sensor lead.
  5. If equipped with all-wheel drive (AWD) remove the wheel drive shaft nut. Refer to Rear Wheel Drive Shaft Replacement .

    6. Object Number: 809968 Size: SH
  6. Remove the wheel bearing/hub assembly knuckle bolts (1).

    7. Object Number: 809973 Size: SH
  7. Remove the wheel bearing/hub assembly (1) from the knuckle (2).

Installation Procedure

    Object Number: 809973 Size: SH
  1. Install the wheel bearing/hub assembly (1) on to the knuckle (2).

    2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 809968 Size: SH
  2. Install the bolts (1) into the wheel bearing/hub assembly.

    3. Tighten
    Tighten the wheel bearing/hub bolts to 130 N·m (96 lb ft).

  3. Install the wheel drive shaft into the wheel bearing and tighten the nut. Refer to Rear Wheel Drive Shaft Replacement .

    4. Tighten
    Tighten the nut to 260 N·m (192 lb ft).

  4. Connect the sensor lead.
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.

Rear Wheel Bearing and Hub Replacement Front Wheel Drive/ Drum

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the brake drum. Refer to Brake Drum Replacement in Drum Brakes.

    4. Object Number: 813284 Size: SH
  4. Remove and DISCARD the wheel bearing/hub bolts.
  5. Remove the wheel bearing/hub.

    6. Object Number: 230412 Size: SH
  6. Disconnect the wheel speed sensor electrical connector (2).

Installation Procedure

    Object Number: 230412 Size: SH
  1. Connect the wheel speed sensor electrical connector (2).

    2. Object Number: 813284 Size: SH
  2. Install the wheel bearing/hub.

    3. Notice: Refer to Fastener Notice in the Preface section.

    Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.

  3. Install the NEW wheel bearing/hub bolts.

    4. Tighten
    Tighten the NEW wheel bearing/hub bolts to 80 N·m (59 lb ft).

  4. Install the brake drum. Refer to Brake Drum Replacement in Drum Brakes.
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.