Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Record all presets and theft codes from the radio.
- Turn off all the lamps and accessories.
- Turn the ignition OFF.
- Loosen the negative battery cable (2) nut.
- Remove the negative battery cable from the battery.
Installation Procedure
Important: Clean any existing corrosion from the battery terminal bolt flange and the battery cable end.
- Install the negative battery cable to the battery.
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the negative battery cable (2) nut.
Tighten
Tighten the nut to 16 N·m (12 lb ft).
- Reprogram the radio presets. Refer to
Radio Setup
.
- Re-initialize the power sliding doors. Refer to
Rear Side Door Actuator Control Module Programming and Setup
.