For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit/System Description
The instrument panel cluster (IPC) displays the vehicle speed based on the information from the engine control module (ECM). The ECM converts the data from the vehicle speed sensor to a 4000 pulses/mile signal. The ECM sends the vehicle speed information via class 2 serial data circuit to the IPC in order to display the vehicle speed and miles traveled.
Diagnostic Aids
Check for the following DTCs:
Reference Information
Schematic Reference
Connector End View Reference
Displays and Gages Connector End Views
Electrical Information Reference
Scan Tool Reference
Circuit/System Testing
- Ignition OFF, raise the vehicles drive wheels.
- Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
- Verify that the odometer is operating properly.
| ⇒ | If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC. |
| ⇒ | If the odometer is not operating properly, replace the IPC. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for IPC replacement, setup, and programming
