The fuel level sensor changes resistance in response to the fuel level. The engine control module (ECM) monitors the signal circuit of the fuel level sensor in order to determine the fuel level. When the fuel tank is full, the sensor resistance is low and the ECM senses a low signal voltage. When the fuel tank is empty, the sensor resistance is high and the ECM senses a high signal voltage. The ECM uses the signal circuit of the fuel level sensor in order to calculate the percentage of remaining fuel in the tank. The ECM sends the fuel level percentage via serial data to the instrument panel cluster (IPC) in order to display the fuel gage. The fuel information is also used for misfire and evaporative emission (EVAP) diagnostics.

Fuel Level Specifications

Fuel Level Specifications

Schematic Reference

Connector End View Reference

Electrical Information Reference

Scan Tool Reference

Scan Tool Data List

1. Ignition OFF, disconnect the harness connector at the fuel level sensor. Install a signal generator and instrument panel tester between the signal circuit and the low reference circuit.
2. Ignition ON, vary the resistance on the signal generator from 40-250 ohms. Verify that the scan tool Fuel Tank Level Remaining parameter displays the correct fuel level percent.

⇒	If the fuel level percent is incorrect, test the signal circuit and the low reference circuit for an open/high resistance. If the circuits test normal, replace the ECM.

3. Ignition ON, vary the resistance on the signal generator from 40-250 ohms and monitor the fuel gage.

⇒	If the gage is incorrect, replace the IPC.

4. If all circuits test normal, test or replace the fuel level sensor.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.