GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2009 🢒 Montana SV6 🢒 Safety and Security 🢒 Object Detection 🢒 Rear Object Alarm Module Replacement

Removal Procedure

    Object Number: 733623 Size: SH
  1. Remove the right rear compartment side trim. Refer to Rear Quarter Trim Panel Replacement - Right Side .
  2. Disconnect the electrical connector from the rear object detection module.
  3. Remove the mounting bolts from the rear object detection module.
  4. Remove the rear object detection module from the vehicle.

Installation Procedure

    Object Number: 733623 Size: SH
  1. Align the rear object detection module to the vehicle.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the rear object detection module mounting bolts and tighten to 10 N·m (89 lb in) .
  3. Install the electrical connector to the rear object detection module and press in the locking tab.
  4. Install the rear compartment side trim. Refer to Rear Quarter Trim Panel Replacement - Right Side .
  5. Refer to Control Module References for programming and setup information.