This DTC is generated by the module when the Theft Lock is activated. This occurs when the VIN as received over the data communication circuit and the VIN as stored in the module memory do not match. This also occurs when no VIN is received over the data communication circuit. The only circuit required is the communication line.

This DTC test runs when the radio changes from OFF to ON.

This DTC is generated by the module when the VIN as received over the data communication circuit and the VIN as stored in the module memory do not match. This also occurs if no VIN is received over the data communication circuit.

The radio does not function. The radio will display indicate that Theftlock is active.

Re-calibration with the correct calibrations for the vehicle and cycling the radio to OFF then to ON will clear the DTC if there is no damage to the radio.

Schematic Reference

Radio/Navigation System Schematics

Connector End View Reference

Entertainment/Communication Connector End Views

Description and Operation

Radio/Audio System Description and Operation

Electrical Information Reference

1. Preform the appropriate radio programming or setup as directed in Control Module References.

⇒	If the DTC resets, replace the radio.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for radio replacement, setup, and programming